Intellinet Network IP Camera Uživatelská příručka stáhnout pdf (Strana 19)

NETWORK IP CAMERA User’s Guide

4.3.2 Assigning IP Address

Follow the below steps to assign IP address by using Hyper Terminal

① Execute “Hyper Terminal” on your PC

② Connect RS232 Cable to the serial port of PC that you have selected in ‘4.3.1 Configuring Hyper

Terminal’ and Network IP Camera serial port while Hyper Terminal is executed.

③ Supply the power to Network IP Camera.

④ After a while, the count down starts with the message “Press 'p' key to stop auto-boot or Load-

Default-Button under the NetCam for 3 seconds...”

At this time, press ‘p’ key. Then, [Network IP Camera Boot] prompt shows like the below image.

⑤ You can see Network Configuration while [Network IP Camera Boot] Prompt is running by

pressing ‘p’ key again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 70 71

Žádné komentáře

Intellinet Network IP Camera Uživatelská příručka Strana 19